OPERATION
DISPLAY
7. Close the door, display will
return blank after 1 minute.
2.6. To Read Cycle Counter
OPERATION
DISPLAY
1. Open the door and leave it
open.
2. While pressing Stop/Reset
pad, press Power Level
pad. eg. 0010 means the oven
has been used 1,000 times.
9999 means the oven has
been used 999,900 times.
3. 2 seconds later, the display will
return to "0".
2.7. To Select Beep Tone Options
(ON/OFF of Beep Tone)
OPERATION
DISPLAY
1. Open the door.
2. Press Prog
pad.
3. Press 0 pad.
4. Press 0 pad again.
(No beep tone setting)
5. Press Prog
pad again.
You have completed
programming the beep tone
option.
6. 2 seconds later, the display will
return to "0".
2.8. To Lock Program of Memory
Pad
OPERATION
DISPLAY
1. Plug the power supply cord into
wall receptacle.
- Display must be blank -
2. Press and hold in the Prog
pad until the display shows "P"
and "L".
(Approximately 6 seconds)
NOTE: When oven is in
"program lock mode", display
will not show anything and
remain blank.
2.9. To Release the Memory Pad
Program Lock
OPERATION
DISPLAY
1. Plug the power supply cord into
wall receptacle.
2. While pressing and holding the
Stop/Reset
pad, press and
hold in the Prog
pad until
the display shows "P".
(Approximately 6 seconds)
NOTE:
When oven is in "program
unlock mode", display will not
show anything and remain
blank.
8
NE-1027 / NE-1037
