14
Troubleshooting
Check the following before requesting service.
Symptoms
Checkpoints
T
ime
Remaining time
fl
uctuates.
●
Remaining time is corrected during the process and displayed.
(Time indication is an approximation.)
Main unit
No operation.
●
Power failure?
●
Is the lid closed completely?
●
Is the power fuse or the breaker cut off?
●
Is the power plug plugged in completely?
●
Is the water faucet turned on?
●
Is the “Start” button pressed?
●
Has the Reserve program been set?
Cannot change the operation
contents. (after start)
●
The contents can be changed in Wash process by pressing “Pause”. To change the
course or to change the contents after Rinse process, turn the power off and then on
again.
The power is not turned on
immediately after power-off.
●
Button operation is ignored approx. 10 seconds after power-off.
W
ash
No water supply.
●
Is the water faucet turned on?
●
Water failure?
●
Is the water supply
fi
lter clogged with dust? (P. 11)
Water is supplied in the middle
of Wash process.
●
When level goes down, water is supplied automatically.
●
With large amount of laundry, water is supplied several times automatically.
The water level is too high for
the amount of laundry.
●
If the laundry is wet or if there is water in the tub before operation, the water level
may be higher.
The water level is too low for the
amount of laundry.
●
With light clothes (synthetic
fi
bre, etc.), the water level may be lower.
Rinse/Spin
The operation started with Rinse
process, however, water is not
supplied.
●
If there is no water in the tub, water is supplied after spin.
●
If there is water in the tub, water is supplied after water discharge.
The operation suddenly changes
to rinse process in the middle
of spin process. / Only spin is
desired, however, the operation
starts with rinse.
●
If the laundry is unevenly placed in the tub, the machine starts to rinse and
automatically corrects the arrangement.
(Put the laundry as evenly as possible.)
Irregular rotation during spin.
●
The tub rotation speed is adjusted to reduce bubble foaming during spin.
Others
Power failure. /
The breaker has tripped.
●
The operation will stop. When power is recovered, the operation will resume.
(“Auto Restart” indicator lights up.)
Water failure.
●
After water supply is recovered, remove the water supply hose to release muddy
water from the faucet, and start the operation.
Operation does not
fi
nish even
after the reservation time.
●
Operation time will become longer if laundry leans to one side or water supply or
drainage is ill-conditioned.
Cannot select 5 Fragrance
course.
●
If Child Lock (P. 10) has been set,
5
Fragrance course cannot be selected.
W9901-8AN00.indd 14
W9901-8AN00.indd 14
8/9/12 9:55 AM
8/9/12 9:55 AM
