Installation Instructions - 41
Checking After Installation
Test run after installation
After the appliance has been completely
installed where it is to be used, run the spin
cycle to check for water leaks, abnormal
noises, and whether the water gets
properly drained off.
Perform the following procedures
WITHOUT laundry in the drum.
Turn on the tap.
1.
Close the door.
2.
Press the On button, and then select
3.
the Quick 50 programme.
Select the Spin only mode of the
4.
Mode function, using the Option
button, and then press the Start
button.
Wait until the water drains out.
While holding down the
5.
and
Help buttons, press the On button.
Help
When the following numbers are
6.
displayed (3 seconds), press the Help
button.
8:
88
Help
The remaining time is displayed as below.
0:
03
The test is run for about 3 minutes.
Check the following:
Is there any abnormal noise?
-
If so, make sure that the appliance is
level.
Is there any water leakage?
-
If so, make sure that the hoses are
properly connected.
You may get the following errors:
(U11) Unable to drain
-
Are the hoses properly connected?
Is the drain clogged?
(U14) Unable to supply water
-
Have you properly connected the water-
supply hose and turned on the tap?
After recovering from an error, reopen and
reclose the door to resume the test.
NA-168VX3_Australia.indb 41
2011-9-5 16:17:14