36 - Installation Instructions
Moving and Installing
Removing the anchor bolts
Four anchor bolts keep the interior of the
appliance in place while the appliance
is being moved. Remove them before
installation, using the spanner that is
supplied with the appliance. Follow the
following instructions.
Note
The anchor bolts must be removed
before the appliance is operated.
They may cause excessive vibration.
A
B
Use the ‘B’ end of the spanner to
1.
loosen the four bolts.
B
Pull the bolts out horizontally.
2.
Remove the screws, which are next
3.
to the bolt holes.
Push each cover cap (included with
4.
the accessories) over each bolt
hole, and then secure them with the
screws you removed in step 3.
Note
Make sure that you store the anchor
bolts, because they are used when
transporting the appliance. If the
appliance is passed on to another
person, make sure to give the anchor
bolts to that person.
Moving the appliance
Note
Make sure to install the anchor bolts in
the appliance.
Before you move the appliance
Shut the tap and run the appliance to
-
drain the water. Drain any remaining
water from the pump hose. (See page
27.)
Depressurize the water-supply hose and
-
remove it.
Disconnect the power cable.
-
Install the anchor bolts. (See page 37.)
-
NA-168VX3_New Zealand.indb 36
2011-9-6 14:55:36