Washing Instructions - 19
Washing
6. Press the Start button.
The appliance starts supplying water
after draining.
Note
Before any programme is started, the
appliance first drains out any water.
The buzzer will sound and “End”
will appear on the display when the
programme has finished, and the door
will unlock immediately.
Caution
After a high temperature wash, be
careful to not burn yourself when
handling the laundry or touching
the inside of the drum.
Note
-If the detergent is not completely
removed from the laundry by using
the basic programme, use the
Rinse+ function.
-If the load is big, the laundry may
stick to the inside of the drum. This
is normal.
-Leave the appliance door open
to allow the drum to dry out after
removing the laundry.
- Remove the laundry and rearrange
where necessary. Do not leave it in the
drum too long after the programme ends
to prevent colour transfer.
Required time
Required time depends on the programme
and temperature setting.
- Actual time may differ slightly from the
displayed time.
- The displayed time includes the time
needed for the water to fill up and to
drain out, thus it varies depending on
water pressure, drainage and amount of
laundry.
- If the laundry in the drum needs to
be balanced, e.g. to facilitate smooth
spinning, the time will be extended.
Setting the buzzer
To turn on or turn off the buzzer which
sounds when the programme has finished,
follow these instructions.
To turn off the buzzer, hold down the
Rinse+ and Dirt Level buttons and
release them when beeps sound.
The buzzer setting becomes off after three
beeps.
To restore the setting, do the same
procedure.
Changing settings while
washing
After washing has started, the programme,
temperature, spin speed, preset time, Dirt
Level, Prewash/Easy Iron and Rinse+
function cannot be changed.
To change the programme, temperature,
spin speed, preset time, Dirt Level,
Prewash/Easy Iron and Rinse+ function
settings, turn the appliance off and then on
again.
NA-147VR1_HK_English_Main.indd 9
2019/05/07 16:29
