If required
Maintenance and Care
Fault Checklist
Maintenance and Care
Maintenance and Care
Fault Checklist
Filter Mesh of Water lnlet Valve
Preventing frozen water inlet & drain
hoses and internal connection hoses
-
Periodically remove the water inlet hose,
and remove the dirt & stains on the filter mesh.
-
To prevent water splashing, execute the
steps described below before removing
the water inlet hose.
1.Turn off the water tap.
2.Switch on the appliance.
3.Select the [Cotton] program and then
press [Start/Pause] button.
4.Turn off the washing machine after 1
minute. Water is drained from the inlet
hose.
5.Disconnect the water inlet hose and
remove it.
6.Clean the filter mesh, which is located
on the rear of the washing machine.
To do this, use a small brush, for example,
a toothbrush.
7.Re-connect the water inlet hose. Turn on
the water tap and check for leaks.
If the washing machine is delivered in freezing
weather conditions, after setting up, leave it at
room temperature for 24 hours before using.
This will ensure that the water inlet/drain hoses
and internal connection hoses do not become
clogged up with ice.
If your water supply hose freezes, perform the
following procedures:
1.Wrap warm towels around the joints of the
water inlet hose.
2.Add 2 to 3 liters of warm water to the drum.
3.Run the [Spin] program after a dozen of
minutes.
Problem
Cause
T
ime
Rinse
W
ash
Body
-
While washing is in progress, it can only be switched after
【
Start/Pause
】
button is pressed. If you want to change
the programme, temperature, rinse and other items after the
washing machine is started, please turn off machine and turn
on the power again.
-
-
-
Door lock may be activated.
Child lock may be activated.(See P21).
The water temperature or level may be too high
-
Rubber parts may give off a smell when you start using the
appliance, but the smell will go away over time.
Buttons do not work.
Door do not open.
Unusual odour
-
If water exist in the drum, starts from draining.
No water flows into the
appliance during the
rinse process
-
-
The display time is corrected randomly. Therefore, time pause
may occur. The displayed time is the standard time and is
different from the actual needed time.
If the load is not balanced during the rinse process, operating
times will be added, and the rinse time will be extended
accordingly.
The remaining time is
changed
-
During wash process, the Water amount used by the drum
type washing machine is less that used by the pulsator washing
machine.
-
-
See
-
-
(See P24).
The water tap might be turned off.
The water inlet hose may be frozen.(
P24).
The water supply may be disrupted.
The filter mesh may be clogged.
-
-
-
Do not open the door to pour water or hot water into the drum,
otherwise water may not be stored, but may be drained out
immediately.
If you have paused the washing and then restart it, the
appliance may drain out some water.
If drain hose is removed from the fixing screw, water will not
accumulate on the drum.
-
-
If the water level is dropped, water is automatically supplied.
For heavy loads, the water may fill up repeatedly.
-
After the safe water level for overflow is reached, forced
drainage will occur during the wash process.
Water cannot be seen
during the wash
process.
No water going into
the appliance
Water is going into the
appliance, but cannot
be stored.
Water goes into the
appliance during the
wash process
Drainage during the
wash process
Water tap
Joint
Water inlet hose
24
25
(
About 50
℃ )