Maintenance - 31
Maintenance
Cleaning the water supply
filter
Clean the filter if water is not supplied
properly.
Turn the tap off.
1.
Switch on the appliance.
2.
Select the Cotton programme, and
3.
then press the Start button. Drainage
begins when the appliance is started.
After 2 minutes, switch off the
4.
appliance. Water has drained out of
the water supply hose
.
Disconnect the water supply hose
5.
from the appliance.
Clean the filter, which is on the rear
6.
of the appliance.
Use a small brush, for example,
a toothbrush.
If the unit is supplied with the hose
7.
fitted with a water supply valve, turn
off the tap supplying water to the
appliance, disconnect the hose from
the tap and then clean the filter on
the hose in the same way.
Reconnect the water supply hose.
8.
Tighten the plastic joint firmly.
Turn on the tap and then check for
9.
leaks.
Put your finger on the tab near the
3.
front of the softener cover and pull
it up to remove it from the detergent
drawer.
Wash out the detergent residue with
4.
water.
Use a cloth to wipe the water from the
appliance.
Replace the softener cover.
5.
Reinsert the detergent drawer while
6.
pressing down on the tab as shown
in the figure below.
Tab
NA-148VB6_English_Pan-Euro.indb 31
2014-12-22 9:37:11
