Panasonic MX-S101, Operating Instructions Manual

Page: 8 / 30

EN14 EN15
English
Problem Cause and Action
Troubleshooting
(continue)
Please check following points before calling or arranging for repair.
Problem Cause and Action
Ingredients do
not mix well.
●
Did not follow the indicated ingredient portion for 1 batch.
(P. EN10)
●
Did not prepare the ingredients to the indicated sizes.
(P. EN10)
●
Ingredients are hard.
Remove the hard ingredients.
●
Operating time is short.
Lengthen operating time, but not exceed the rated time of
continuous operation.
●
The blade is damaged.
Stop using and contact the store of purchase or Panasonic
service center.
Poor finished
product.
Replacement Parts
Replacement parts are available at your dealer or Panasonic service center.
Part Name Part Number
Beaker (exclude lid/slip-proof mat) AMD02E1421
Specifications
Operation stops
abruptly.
●
Motor overloading protection is activated due to overload.
If blender is pressed strongly against ingredients, release
trigger switch and unlock button, unplug the machine, then
reinsert to operate again. (P. EN11)
●
Do not press blender forcefully into ingredients.
For circumstances other than the above,
perform the following steps while the
blender is stopped.
①
Release trigger switch and unlock
button, then remove motor housing
from the container.
②
Unplug the power plug.
③
Remove half of the ingredients or add
water.
●
If prohibited ingredients were added,
remove them.
④
Repeat preparation and operation.
(P. EN11)
●
Do not press blender forcefully into ingredients.
If machine still does not operate after performing the above,
motor overheating protection has been activated. See below.
●
Motor overheating protection function activated from motor
overheating during or after use.
Unplug and rest the machine for approx. 30 minutes or
more (until motor housing returns to a normal temperature)
to release overheating protection before using again. (If
machine still does not operate, consult the store of purchase or
Panasonic service center.)
( )
Release
Release
Motor housing
becomes hot.
●
Use beyond rated time.
Use within rated time (P. EN15). For continued use, unplug and
rest machine for at least 10 minutes until motor housing returns to
a normal temperature. (Motor overheating causes malfunction.)
Power Supply 220 - 240 V 50 - 60 Hz
Power Consumption 115 - 125 W
Rated Time (continuous operation) 1 minute
Safety Device
Motor overloading protection
Motor overheating protection
Length of Power Cord (approx.) 1.3 m
Dimensions (approx.)
Motor h Attachments (W × D × H)
6.5 × 7.4 × 42.3 cm
Mass. (approx.)
Motor h Attachments
0.8 - 0.9 k g
The blade gets
stuck.
●
Unplug and remove ingredients trapped between metal
parts with the spatula brush. If cannot clearly clean, try
to use a non-metallic pointed object (made of wood is
recommended). (Do not touch rubber portion.)
There is
abnormal noise.
●
Ingredients are hard.
Remove the hard ingredients.