14
3. Uses a minus driver and it removes a safety device by the
point of the lever. (Make not lose a spring.)
6.3.
Bottom plate
1. The bottom plate can be removed when its four screws
are lossened.
6.4.
Connector(Lower)
1. Hold the part under the motor shaft by means of a
screws-driver, then turn the connector (lower) clockwise.
The connector (lower) can be removed.
• The connector (lower) can be relatively easily removed
by means of hitting its projecting section clockwise with
use of a screwdriver grip in a forceful manner.
Summary of Contents for MX-101SG1WTM
