Panasonic MJ-J176PWTC, Service Manual

Page: 10 / 20

10
5.2.3. SYMPTOM : The spinner is difficult to install and remove
5.2.4. SYMPTOM : Juice is poorly extracted
5.2.5. SYMPTOM : Juice contains too much residue
5.2.6. SYMPTOM : Cutter rubs against inlet bottom
5.2.7. SYMPTOM : Leakage of juice
Cause Remedy
The clutch pin of the cutter base doesn’t operate smoothly Examine the clutch pin; replace it if necessary
Foreign materials are clogged between the cutter base and the spinner
base Remove them
Cause Remedy
Cutter doesn’t operate well Replace complete spinner
Spinner is broken Replace complete spinner
Continuous use for a long period Remove the residue
Too large a gap between inlet bottom and cutter blade Adjust it within the range of 0.5 - 0.9mm
Cause Remedy
Cutter blade is worn out Replace the spinner (complete)
Gap between inlet bottom and cutter blade is too large Use two or three adjusting washers on the motor shaft
Cause Remedy
Gear incompletely engaged between cutter base and spinner Engage the gear
Too many adjustment rings on the motor shaft Decrease the number of adjustment rings and adjust the gap within the
range of 0.5 - 0.9mm
Cause Remedy
Container and/or cover deformed or broken Replace the container or cover
Incorrect clasp fastening Examine the clasp; adjust the fastening force
Foreign materials are clogged between the container cover and the
container Clean it and remove them
Excessive vibration Clean it and adjust the spinner balance