EN5
English
400
600
800
1000
■
Wet & Dry Mill
●
The SAFETY LOCK has been designed to prevent the blender or the wet & dry mill from switching on when the
blender jug or the mill container is not properly in place.
●
Do not push the safety lock pins with any instrument, stick etc.
Attach the blender jug or mill container to each container base properly.
●
After setting, make sure the bottom of each container base is as shown in the illustration.
■
Blender
■
Juicer
■
Accessory
Brush
Power Plug *2
Safety
Lock Pins
Overload and Overheating Protection
In case of overload and overheating, the protection device is triggered to stop operation and it is not abnormal.
After rotation stops, follow the below steps:
●
Do not use the appliance repeatedly without any countermeasure.
1
Turn the rotary switch to “0” position, unplug the appliance.
2
Remove attachment from motor housing. Remove the excess ingredients from the blender jug/mill container or
remove accumulated food residue from the spinner/container cover and ensure that the amount used is as stated.
(For blender jug, it also can add liquid.)
●
Ensure that the ingredients are cut into the stated sizes.
●
Remove the prohibited ingredient if used.
3
Reset the attachment, then start again. (P. EN7)
If the appliance still does not operate after performing the above, overheating protection has been activated.
Turn the rotary switch to "0" position, unplug and rest the appliance for about 15 minutes or more (until motor housing returns to a
normal temperature) to release overheating protection before using again.
(If appliance still does not operate, Contact Panasonic Service Centre for inspection or repair.)
Parts Names and Instructions
Food Pusher
Feeding Tube
Container Cover
Pulp Container
(Approx. 2.0 L)
Spinner Pad
Spinner
Container Unit
Cup Cover
Juice Cup
(Approx. 1.5 L)
Container
Spout
2
High speed
(continuous operation)
1
Low speed
(continuous operation)
0
OFF
Rotary Switch
Cover
One scale
approx. 0.2 L
Blender Gasket
Blender Blade
Blender Jug
Blender Jug Base *1
Maximum amount
approx.1.0 L
Mill Container
Mill Container Base *1
Mill Gasket
Mill Blade
Power Cord
Motor Housing
*1 The blender jug base and the mill container
base cannot be used interchangeably.
*2 The shape of the plug may be different from
illustration.
Clamps
(Both sides)
Summary of Contents for MJ-CB800
Page 19: ...Memo ...
Page 20: ...Memo ...
