No. SX-DSV03335 - 84-
R2.0
Industrial Device Solution Business Unit, Panasonic Corporation
SAFETY PRECAUTIONS
10. Safety precautions
■The degree of the injury or damage caused when using the product improperly is categorized and an explanation is provided.
Indicates “actions carrying a significant risk of death or serious injury.”
Indicates “actions carrying the risk of the occurrence of minor injury or
property damage.”
■The actions to be observed are explained with the following symbols.
Indicates actions that must not be performed.
Indicates actions that must be performed without fail.
(1)
Please use it in the environment of pollution degree 2 or 1 (where there is no foreign matter suc
h as dust, metal powder, oil mist, etc., where it does not come in contact with liquids such as w
ater, oil and grinding liquid). Avoid storing or using it near combustibles or in an atmosphere of
corrosive gas (H2S, SO2, NO2, Cl2 etc.) or flammable gas.
(2)
Do not place combustible objects near the motor, servo driver, or regenerative resistor.
(3)
Do not drive the motor with external power. As the motor is driven from the outside, it becomes
a generator, so a short circuit current will flow during the dynamic brake operation built into the
servo driver, possibly causing smoke and dust. Also, the dynamic brake may break and the brake
may not operate.
(4)
Do not damage the cable, apply excessive stress, place heavy objects on it, or pinch it.
(5)
Please do not use cable with oil and water soaked.
(6)
Do not install near heating elements such as heaters or large winding resistors. (Provide a heat shi
eld plate, etc. so that it is not affected by the heating element.)
(7)
Do not connect commercial power directly to the motor.
(8)
Please do not use in places subject to vibration / shock. When installing the servo driver near the
vibration source, attach the vibration isolator to the servo driver mounting surface.
(9)
Do not touch the rotating parts of the motor during operation.
(10)
Do not touch the key groove of the motor output shaft with bare hands.
(11)
Do not touch the inside of the servo driver.
(12)
Temperature of the heat sink and peripheral devices of the motor / servo driver will increase, so
please do not touch it.
(13)
Do not wire or operate with wet hands.
DANGER
DANGER
CAUTION
