92
How to Use the Console
Step Parameter
Step parameter can be set.
* An example to set in ST.Pr1 is shown below.
Press .
Press .
Press .
Press .
Press .
Press .
Press .
Press .
Step data
(low order)
Step data
(high order)
.....ST.Pr02
.....ST.Pr01
.....Speed number selection
A selected parameter
is shown.
* The data is shown on the
two screens because of a
large number of displayed
digits.
.....Acceleration number selection
.....Deceleration number selection
.....Operation mode selection
.....Block selection
.....ST.Pr60
.....ST.Pr01
<Notice>
Select an input digit (a dot blinks) by the [SHIFT] key and a parameter by the [UP]/[DOWN] key.
The step data is shown on the two screens because of a large number of displayed digits.
If the parameter is a negative value, a dot lights.
When you press the [SET] key, the parameter is modified.
* When you press during parameter setting, any parameter in process is not changed and “No.”
display is shown again.
* When you have set the parameters, write the parameters into EEPROM. If you turn the power supply
off before writing the parameters into EEPROM, those parameters are cleared.
