3
MN103S Emulator Target conversion adapter Installation
*1
*2
*2
*2
9. Connect the flexible cables with
the conversion board and the target socket board.
10. Installation has been completed.
*1
*2
1. Replace screws on the bottom
surface of the emulator housing by
screws with spacers and rubber
feet.
2. The screws have been replaced.
3. Insert the
longer
side of
joining screws into the emulator
housing.
4. Put the conversion board on the
joining screws.
(Make sure to join the mark ”A1”)
5-1. Tighten the rear two
screws evenly.
5-2. Tighten the front two
screws evenly.
Alternate
5-1 and 5-2
6. The conversion board has
been installed if there is
no space.
Note:
*1 When connecting parts, make sure to join the marks "1 pin" and "A1" respectively.
*2 Special attentions should be paid to needle-points of YQPACK and the conversion board
not to bend or break them.
Software & Solutions Development Center
Corporate System LSI Development Division
Semiconductor Company
Matsushita Electric Industrial Co., Ltd.
Ex) Target board
7. Screw NQPACK (Sold separately)
and YQPACK by YQ-Guide.
(Note the corner cut)
8.
Insert the target socket board
(EXB-128SD-PA) along YQ-Guide .
(straight from on.
)
S/N. 081-31E-624A1-103S
Apr 14, 2008
