4.4. CARBON BRUSH
4.4.1. Removal
1. Complete brush change on one side before starting on the
other side.
2. There are two (2) brushes located on the motor as identified
in the illustration below.
3. Remove the brush assembly by using a Phillips head
screwdriver to remove the screw that holds the brush holder
onto the motor.
4. See the illustration above for screw location.
NOTE: Do not drop screws into the motor.
4.4.2. Replacement
1. Place new brush assembly on the motor.
2. Make sure that the amp terminal on the bottom of the brush
assembly is inserted into the receptacle on the motor.
3. Replace the Phillips screw that was removed.
4. Repeat steps in Removal & Replacement steps for the
other brush assembly.
NOTE: Do not drop screws into the motor.
13
MC-V9634-00