3. Turn the vacuum cleaner over to the front side.
4. Remove the four (4) screws from the motor case and then
remove the motor case.
5. Disconnect the motor leads and remove the motor. Remove
the motor support rubber (rear), noise suppressor, and the
motor support rubber (front). Place these items on the new
motor.
3.5.2. Installation
1. Place the motor back into the dust compartment with
brushes aligned parallel to the front edge of the dust
compartment.
2. Rewire per the Pictorial Diagram.
3. Replace the motor case and the four (4) screws.
4. Turn the vacuum clenaer back over and replace the plastic
holder, thick side out, plastic shaft, light bulb assembly,
nozzle housing, belt, agitator assembly, and lower plate
according to the respective installation instructions.
12
MC-UG581-01
