30
8.4.
Disassembly Procedure for the
Lens
NOTE: When Disassembling and Assembling for the Lens
1. To minimize the possibility of the CCD being dirt, perform
disassemble and/or assemble under the condition of the
CCD is being mounted.
Disassembling procedures for the CCD unit, refer to item
8.6..
2. Take care that the dust and dirt are not entered into the
lens.
In case of the dust is putted on the lens, blow off them by
airbrush.
3. Do not touch the surface of lens.
4. Use lens cleaning KIT (BK)(VFK1900BK).
5. Apply the grease (RFKZ0472) to the point where is
shown to “THE APPLICATION OF GREASE METHOD“ in
the figure.
When the grease is applied, use a toothpick and apply
thinly.
6. When repair the fixed frame unit, drive frame unit and
penetration cam frame, must be unit exchange.
8.4.1.
Removal of the Zoom Motor and
Lens FPC Unit
1. Remove the 7 solders (A).
2. Remove the 1 lock.
3. Unscrew the 2 screws (A).
4. Remove the zoom motor to the direction of arrow (1).
5. Remove the 4 solders (B).
Summary of Contents for LUMIX DMC-ZR1GC
