Panasonic Lumix DMC-TZ8EB, Service Manual, Page: 11 / 68

11
3.4.2. INITIAL SETTINGS:
After replacing the MAIN P.C.B., make sure to perform the initial settings after achieving the adjustment by ordering the following
procedure in accordance with model suffix of the unit.
1. IMPORTANT NOTICE:
Before proceeding Initial settings, be sure to read the following CAUTIONS.
2. PROCEDURES:
• Precautions: Read the above "CAUTION 1" and "CAUTION 2", carefully.
• Preparation:
1. Attach the Battery or AC Adaptor with a DC coupler to the unit.
2. Set the mode dial to the PROGRAM AE mode.
Note: If the mode dial position is other than PROGRAM AE mode, it does not display the initial settings menu.
• Step 1. The temporary cancellation of "INITIAL SETTINGS":
Set the REC/PLAYBACK selector switch to “REC (Camera mark)”.
While keep pressing “UP of Cursor button” and DISPLAY button simultaneously, turn the Power on.
• Step 2. The cancellation of "INITIAL SETTINGS":
Set the REC/PLAYBACK selector switch to "PLAYBACK".
Press "UP of Cursor button" and [DISPLAY button simultaneously, then turn the Power off.
• Step 3. Turn the Power on:
Set the REC/PLAYBACK selector switch to "REC (Camera mark)", and then turn the Power on.
• Step 4. Display the "INITIAL SETTINGS" menu:
Note: If the unit is other than PROGRAM AE mode, it does not display the initial settings menu.
While keep pressing MENU/SET and "RIGHT of Cursor button" simultaneously, turn the Power off.
The "INITIAL SETTINGS" menu is displayed.
There are two kinds of ”INITIAL SETTINGS” menu form as follows:
[CASE 1. After replacing MAIN P.C.B.]
When MAIN P.C.B. has just been replaced, all of the model suffix are displayed as follows. (Five pages in total)