VQT4U14 (ENG)
12
2
Drain water by holding the camera
upside down and shaking it lightly a few
times.
•
Make sure to put your hand through the strap
to prevent the camera from falling.
3
Wipe off water drops on the camera with a
soft, dry
cloth and dry the camera in a
shaded area that is well ventilated.
•
Dry the camera by standing it on a dry cloth.
This unit incorporates drain design, draining
water in gaps in the camera [ON/OFF] button
and zoom button etc.
•
Do not dry the camera with hot air from dryer
or similar. Waterproof performance will deteriorate due to deformation.
•
Do not use chemicals such as benzine, thinner, alcohol or cleanser, soap or
detergents.
4
Confirm that there are no water droplets, open the side door, and wipe off
any water droplets or sand left inside using a soft, dry cloth.
•
Water droplets may adhere to the card or battery when the side door is opened without
thoroughly drying. Also, water may accumulate in the gap around the card/battery slot
or the terminal connector. Be sure to wipe any water off with a soft, dry cloth.
•
The water droplets may seep into the camera when the side door is closed while it is
still wet, causing condensation or failure.
DMC-FT5&TS5GH-VQT4U14_eng.book 12 ページ ２０１３年１月３０日 水曜日 午後１２時８分