Panasonic Lumix DMC-GH1KPP, Service Manual

Page: 25 / 86

25
[MEMORY CARD ERROR
PLEASE CHECK THE CARD]
s
An error has occurred accessing the card.
Insert the card again.
Insert a different card.
[READ ERROR/WRITE ERROR
PLEASE CHECK THE CARD]
s
It has failed to read or write data.
Remove the card after turning the power [OFF]. Insert the card again, turn the power on,
and try to read or write the data again.
s
The card may be broken.
Insert a different card.
[CANNOT RECORD DUE TO INCOMPATIBLE FORMAT (NTSC/PAL) DATA ON THIS
CARD.]
If you want to delete some pictures, format the card after saving necessary data on a PC
etc.
Insert a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
s
It is recommended to use a card with SD Speed Class with “Class 6” or higher when
recording motion pictures.
SD speed class is the speed standard regarding continuous writing.
s
When you set the picture quality to [ ], [ ] or [ ], we recommend using a high-speed
card with “10MB/s” or greater displayed on the package.
s
In the event that it stops even after using a “10MB/s” card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format.
s
Depending on the type of SD Memory Card or SDHC Memory Card, motion picture recording
may stop in the middle.
[A FOLDER CANNOT BE CREATED]
s
A folder cannot be created because there are no remaining folder numbers that can be used.
Format the card after saving necessary data on a PC etc. If you execute [NO.RESET]
in the [SETUP] menu after formatting, the folder number is reset to 100.
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
s
The AV cable is connected to the camera.
Press [MENU/SET] if you want to delete this message at once.
Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect.
s
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer.
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
s
The printer cannot print.
Check the printer.
[NO BATTERY POWER REMAINS]
s
The remaining battery power is low.
Charge the battery.
[THIS BATTERY CANNOT BE USED]
s
The battery cannot be recognized by the camera.
Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Center.
s
The battery cannot be recognized as its terminal is dirty.
Remove any dirt etc. from the terminal.
[PLEASE MAKE SURE TO TURN ON THE POWER OF EXTERNAL MICROPHONE.]
s
When attaching the stereo microphone (DMW-MS1; optional), check the battery status and
make sure the power is on before use.