10
3.4.2.
INITIAL SETTINGS:
When you replace the Main PCB, be sure to perform the initial settings after achieving the adjustment by ordering the following pro-
cedure in accordance with model suffix of the unit.
1. IMPORTANT NOTICE:
Before proceeding Initial settings, be sure to read the following CAUTIONS.
2. PROCEDURES:
• Preparation. Proceed the picture back up from the unit (Refer to above "CAUTION 2")
•
Step 1. The temporary cancellation of initial setting:
Set the mode dial to “[ Normal picture mode ] (Red camera mark)”.
While keep pressing [E.ZOOM ] and “[ UP ] of Cross key” simultaneously, turn the Power on.
•
Step 2. The cancellation of initial setting:
Set the mode dial to “[ Playback ]”.
Press [E.ZOOM ] and “[ UP ] of Cross key” simultaneously, then turn the Power off.
•
Step 3. Turn the Power on:
Set the mode dial to “[ Normal picture mode ] (Red camera mark)”, and then turn the Power on.
•
Step 4. Display the INITIAL SETTING:
While keep pressing [ MENU ] and “[ RIGHT ] of Cross key” simultaneously, turn the Power off.
Summary of Contents for Lumix DMC-FX100P
