Panasonic LP-V Series, Operation And Maintenance Manual

Page: 216 / 334

216
Description
7 Marking Time Measurement :
Indicates the period of marking.
Press [MARKING TIME MEASUREMENT].
Reference
• If a variable character such as counter is included in the character marked, the measurement of period is performed
with the current value.
• In case the actual marking period is shorter than the one-shot output duration, the result of measurement is same as
the one-shot output time. Refer to “4-16-3 Communication, I/O Setting (Environment 3)” (P.261) for the detail of the one-
shot time setting.
8 Line Speed :
Used at measurement of marking period.
It is indicated when the moving direction in the trigger setting is set to other than “still”.
Measure the line speed in consideration of the line speed of the flying object.
Setting Range
0.060 to 240.000 m/min (LP-430 / LP-420 / LP-435 / LP-425 / LP-V10 / LP-V15)
0.060 to 170.000 m/min
(LP-410)
0.060 to 120.000 m/min (LP-431 / LP-421 / LP-W052)
0.060 to 85.000 m/min (LP-411)
9 Fly. Obj. Wait (Flying Object Wait)
Used at measurement of marking period.
Waiting period for marking corresponding to the line speed for flying object marking.
It is indicated when the moving direction in the trigger setting is set to other than “still”.
Setting Range 0.00 to 500.00ms
10 Start Point :
11 End Point :
With this function, the timing for turning on the laser at the starting or ending point is adjusted.
The smaller the value is, the darker (deeper) the marked character at the starting or ending point is.
Setting Range -100 to 100
Initial Value 0
Light (Shallow) Dark (Deep) Optimal
Setting value
Light (Shallow)
Small
Dark (Deep)
Large
Optimal
Notice
• Too small value for the adjustment of start/end point may be the cause of chipped character.
12 ADJUST. :
They will provide fine adjustment of marking quality.
For details of setting item, refer to “4-11-2 Detail Adjustment (Laser Setting)” (P.217).
ME-LP400V-OP-6