Panasonic LP-RH Series, Setup And Maintenance Manual

Page: 65 / 240

65
2-6-5 Connection of Console
This product can be used for monitoring and setting during operation by connecting the touch panel console LP-ADP50 (sold
separately). Touch panel console is available when the optional expansion board is installed to the controller. Refer to “2-5
Expansion board installation” (P.55).
„
Connection procedure
1.
Turn off the key switch of the controller.
ワㄐㄕㄊ㄄ㄆ
• Do not connect or disconnect the console while the laser marker is powered on.
2.
Connect the console to the console connector (CONSOLE) on the front of the controller.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• When using the console, you need to set it in advance with Laser Marker NAVI smart. For details, refer to “Console
Operation Manual”.
• When operating the laser marker using a touch panel console or a commercially available monitor, turn off the power
of the laser marker and connect these display devices. If the touch panel console or a commercially available monitor
shows nothing after turning on the power of the laser marker, make sure that the cables inside the controller are
connected to the expansion board correctly.
ME-LPRH-SM-3