Panasonic LP-RH Series, Setup And Maintenance Manual

Page: 109 / 240

109
4-4 I/O Rating/Circuit
4-4-1 Input rating and input circuit
This section shows the input rating and the input circuit for the I/O terminal block input and the I/O connector input. Note
that the input rating and circuit of INTERLOCK terminals (X16, X17, X18, X19) are different from those shown here. Refer to
“4-4-3 Interlock terminal rating and I/O circuit” (P.111).
„
Input rating
Item I/O terminal block input, I/O connector input
Input form Bidirectional photo coupler insulation input
Input ON voltage Difference of voltages between input and input common: 19V or more
Input OFF voltage Difference of voltages between input and input common: No more than 3V or open
Rated input voltage +24V DC+/-10%
„
Input circuit
In
te
rn
al
c
irc
uit
INPUT
Input common
(IN COM.)
„
NPN sample
„
PNP sample
IN
PU
T
IN
PU
T
Input common
(IN COM.)
Input
common
(IN COM.)
External power
supply
(+24V DC)
External power
supply
(+24V DC)
NPN open
collector output
PNP open
collector output
Each input
Each input
ワㄐㄕㄊ㄄ㄆ
• This product supports both the NPN transistor output and the PNP transistor output. However, the wiring from I/O
terminal block and the I/O connector respectively cannot be used as NPN/PNP mixed. Operate the product after
selecting either NPN or PNP.
• Do not short-circuit 24V OUT (X1, Y3) and 0V OUT (Y1, X3). Also, do not short-circuit IN COM. 1 (X2) and OUT COM.1
(Y2, X12). Starting the laser marker with these terminals short-circuited will cause the laser marker to malfunction.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• Respective inputs are bidirectional photo-coupler inputs. The regulation for input ON is based on the ON status of photo-
coupler.
• IN COM. 1, OUT COM. 1 of the I/O terminal block and IN COM. 2, OUT COM. 2 of the I/O connector are independent.
If you use the I/O connector terminal, connect input common/output common of the I/O terminal block and the I/O
connector to power supply respectively.
• DC 2-wire sensor cannot be connected to any input.
ME-LPRH-SM-3