Panasonic LP-GS Series, Setup & Maintenance Manual

Page: 61 / 190

61
3-3-6 Test marking and RUN mode
When you execute marking using the PC configuration software control, the laser irradiates in the following methods:
„
Test marking procedure
Test marking is a marking method of radiating laser by the button operations on the Laser Marker NAVI smart setting
screen.
1.
Select any of the following screens:
• Marking settings
• Operator settings (when test marking is enabled)
2.
Click “Laser pumping ON/OFF” of the “Laser Marker Operation” tool.
3.
Click “Test marking” on the test marking/guide laser panel.
If you do not see the test marking/guide laser panel on the screen,
click “Test marking/guide laser” of the “Laser Marker Operation” tool
and display the panel.
4.
A confirmation dialog box of the laser radiation appears. Click “Yes” to start radiating the laser.
„
RUN mode procedure
The RUN mode is an operating method of radiating the laser by external control or by the marking start signal from Laser
Marker NAVI smart while the laser marker is in the marking start signal standby state.
1.
Select any of the following screens:
• Marking settings
• Operator settings
• Monitor
2.
Click “Laser pumping ON/OFF” of the “Laser Marker Operation”
tool.
3.
Click “RUN mode ON/OFF” of the “Laser Marker Operation” tool.
4.
When you turn ON the RUN mode, the laser marker
enters into the marking start signal standby state.
Enter the marking start signal (marking trigger) in any of the
following methods to irradiate the laser beam.
• Switches or sensors connected to TRIGGER IN (X5) on the I/O
terminal block
• Laser Marker NAVI smart screen operations
Switch for
marking trigger
ME-LPGS-SM-8