Panasonic LB-DH7 Series, Operator'S Manual

Page: 80 / 92

80
Others Errors and warnings
List of warning codes
Code
Email
notification
SNMP trap
notification
Action to be taken
W1000
○ ○
A fault has been detected in the external power supply unit. (When
“Enable Power Supply Monitoring” (
> 47) is disabled (default).)
)
Replace the external power supply with reference to the manual
for the external power supply in use.
≥ Values written in the “0xXX” format are the hexadecimal numbers
converted from binary numbers that denote the locations of external
power supply units with faults.
(Examples) 0xXX: indicates a fault in the external power supply unit in
the leftmost slot of the shelf;
0x05: indicates faults in the external power supply units in the leftmost
slot of the shelf and the third slot from the left side of the shelf
W1000-0
○ ○
A fault has been detected in the external power supply unit. (When
“Enable Power Supply Monitoring” (
> 47) is enabled.)
≥
Values written in the “0xXX” format are the hexadecimal numbers
converted from binary numbers that denote the locations of external
power supply units with faults.
(Examples) 0xXX: indicates a fault in the external power supply unit in
the leftmost slot of the shelf;
0x05: indicates faults in the external power supply units in the leftmost
slot of the shelf and the third slot from the left side of the shelf
W1000-1
○ ○
Communication with the external power supply unit has failed.
(When “Enable Power Supply Monitoring” (
> 47) is enabled.)
W1001
± ±
A fault has been detected in the fan of the unit or the peripheral circuit of the fan.
It needs to be repaired.
W1010
± ±
The software update has failed.
) Refer “Software problems” ( > 72) to take proper action.
W1030
s ±
Email submission to the SMTP server has failed.
)
Check if the network setting for the SMTP server is correct.
W1041
± ±
Detected that the life of the HDD in the server connected to the unit
is nearly at its end.
)
We recommend to replace the flash memory unit.
≥ This warning function detects only the life of the HDD in a recommended server.
W1042
± ±
The rotation speed of fan has dropped.
) It is recommended that the fan and the peripheral circuit be maintained.
W1050
s s
Could not detect any magazine.
)
Withdraw the magazine drawer to make sure the installation of
magazine is correct. (
>
20)
If the problem persists, please contact your support service provider. (
>
83)
W1102
s s
The command for turning on or off was set while the unit was
processing the previous command for turning itself on or off.
)
Wait until the unit turns on or off.
W1103
s s
The unit cannot be turned off because the software is being updated.
) Try again after the update is complete.
W1104
s s
The unit cannot be turned off because the magazine eject mode is set.
)
Turn off the magazine eject mode on the application, and try again.