Page 1-51
REGULAR
MAINTENANCE
1
Check Every 1000 Hours (Once Two Months)
1-6-5
Cleaning and Lubricating the Board Positioning Lift
1.
Turn off the Power.
2.
Open the front and center safety
covers.
3.
Remove the
θ
-axis cover.
4.
Clean the bearing, linear bearing, ball
screws, linear shaft, and rotary com-
ponent then apply grease.
1.Ball screw for automatic width adjustment
Apply grease to the ball screw.
2.Linear bearing for automatic width adjust-
ment
Apply grease to the rail.
3.Linear bearing for board side clamp
Apply grease to the rail.
4.Ball screw for support (4 points)
Apply grease to the ball screws.
5.Ball screw for lifter (4 points)
Apply grease to the ball screws.
6.Linear shaft for lifter (4 points)
Apply grease to the linear shafts.
1E4C-E-MMA01-A08-00
Tools
Cross screw driver
Required time
15 minutes
REL
EA
SE
TR
IP
O
F
F
ON
RE
S
E
T
Linear bearing for board side clamp
Linear bearing for
automatic width
adjustment
Ball screw for
automatic width
adjustment
Ball screw for lifter
Ball screw for support
Linear shaft for lifter
θ
-axis cover
1E4C-405E
To the next page
Summary of Contents for KXF-1E4C
Page 2: ......
Page 6: ...4 1E4C E MMA00 B01 00 MEMO ...
Page 12: ...10 1E4C E MMA00 A02 01 MEMO ...