Page 3-5
CHANGING THE
PRODUCTION BOARDS
3
3-2
Board Positioning and Adjusting the Lift and Rail Width
NOTICE
When the board gets small (the width of transfer rail gets narrow), take out sup-
port pins of board holder before carrying out the rail width adjustment. If pins are
not taken out, the sensor to prevent touching support pins with the conveyor
works and the automatic width adjustment stops, as “Supporter and conveyor
error” is detected.
The board positioning, and lift and rail width adjustment are carried out, according to new board
data.
M36E
If there are any boards or other objects on the conveyor, turn OFF the servo switch and remove them.
BEFORE PERFORMING AUTOMATIC WIDTH ADJUSTMENT, BE SURE TO
VERIFY NO BOARDS OR OTHER OBJECTS ARE ON THE CONVEYOR.
Boards or other objects may drop from the conveyor, causing damage to the boards or
the machine.
CAUTION
M09E
TAKE CARE NOT TO PINCH YOUR HANDS OR FINGERS.
You will have serious injury if your hands or fingers are caught in the conveyors during
manual (or automatic) width adjustment.
WARNING
193C-E-EMA03-A01-00
Summary of Contents for KXF-193C
