Panasonic KXF-013C, Operating Instructions Manual

Page: 35 / 49

Chapter 1 GENERAL DESCRIPTION Section 4 BASIC OPERATION
4
Page 4-3
4-1-3 How to Set Production Counter (In the case of LC48)
014C-PS009
013C-E-OMA04-A01-01
Set the number of boards
• Press ENTER .
• Press
←
to move "-" to the
position of number which you want
to set it.
• Press SET to enlarge the
number, if it is over 9 it goes back
to 0 .
• If you finish setting, press RESET .
If you UP the counter, OP will be represented and the production finish signal will be output.
When production finished, the red lamp turns on and the next process stop immediately.
If you want to restart the machine, press reset switch of the counter and then press the line
start switch which on the forward stoker operation panel.
Make sure that all of production process are stopped when you restart the machine.
panel front figure
Mode setting
• Press ENTER .
• If you want to set input mode,
"DOWN", keep pressing
INPUT M till "DOWN" is
represented.
• Press RESET .
• If you want to switch to the output
mode, press OUTPUT H .
input mode DOWN
output mode HOLD A
30/1K both of them is OK.
standard setting