Panasonic KX-UT670, Administrator'S Manual

Page: 48 / 250

3.1 Phone User Interface Programming
This section provides information about the features that can be configured directly from the unit, but that are
not mentioned in the Operating Instructions.
For details about the other available features, settings and operations on the phone user interface, refer to the
Operating Instructions on the Panasonic Web site (
®
see Introduction ).
3.1.1 Direct Commands
The following table shows additional features programmable with direct commands. These commands are
hidden from end users.
Direct Command Feature Ref.
[#][7][3][1] Terminal No. Page 48
[#][7][3][9] Reset Web ID/Password
*1
Page 48
*1 Not displayed on the LCD of the unit.
Notice
•
Direct commands cannot be performed if a USB keyboard is connected to the unit. Disconnect the
USB keyboard before performing direct commands.
3.1.1.1 Terminal Number Settings
You can select the terminal number of the unit that you are using from [Terminal 1] – [Terminal 9] , and
[Auto] . The default setting is [Auto] . [Auto] does not assign a fixed terminal number to the unit.
If multiple units try to access the same router simultaneously, errors can occur. Assigning a terminal number
1 to 9 to each of the units may prevent such errors.
To assign a terminal number to the unit
1.
Press on the Home screen, and then tap [Settings] .
2.
Tap [About phone] .
3.
Press and hold .
4.
When the keyboard is displayed, enter [#][7][3][1] , and then press .
5.
Select the desired terminal number ( [Auto] , [Terminal 1] – [Terminal 9] ).
3.1.1.2 Reset Web ID/Password
Reset Web ID/Password resets all the IDs and passwords required for users and administrators to access the
Web user interface (
®
see Access Levels (IDs and Passwords) in 4.2.3 Before Accessing the Web User
Interface ) to their factory defaults. You can perform this operation from the unit.
To perform Reset Web ID/Password
1.
Press on the Home screen, and then tap [Settings] .
2.
Tap [About phone] .
3.
Press and hold .
4.
When the keyboard is displayed, enter [#][7][3][9] , and then press .
48 Administrator Guide Document Version 2012-07
Section 3 Phone User Interface Programming