Panasonic KX-TVM50, Programming Manual

Page: 28 / 200

1.8 Utility
28 Programming Guide
1.8.7 Utility—System Initialise/Restart
The System Initialise/Restart is used to restart the VPS. There are 2 methods as follows:
a)
Initialise System: initialising the system clears all voice data except the installed system
guidance and returns all system parameters to their default settings. The System
Administrator has to specify the following parameters before initialising the system:
– Mailbox No. Length
– System Manager's Mailbox No.
– Message Manager's Mailbox No.
If there are active ports, the System Administrator will be asked to either "Initialise
immediately" or "Wait for end of activity" to close the port.
b)
Restart System: restarts the system. The VPS is not initialised. If there are active ports, the
System Administrator will be asked to "Reboot immediately" or "Wait for end of activity"
before rebooting.
Follow the steps below for to initialise or restart the VPS:
1.
Click Utility in the menu bar.
2.
Select System Initialise/Restart.
Initialise System
1.
Select "Initialise System".
(You can click the icon in the tool bar instead of step 1 and 2.)
2.
Specify "Mailbox No. Length (2–5 digits)", "System Manager's Mailbox No." and "Message
Manager's Mailbox No."
3.
Click OK.
4.
Select "Close immediately" or "Wait for end of activity" if there are active ports.
5.
Click OK.
Reboot System
1.
Select "Restart System".
(You can click the icon in the tool bar instead of step 1 and 2.)
2.
Select "Close immediately" or "Wait for end of activity" if there are active ports.
3.
Click OK.
1.8.8 Utility—Diagnostic
Diagnostic is use to diagnose the following hardware of VPS.
a)
Codec/DSP Voice Path: diagnoses whether the voice path between Codec and DSP
functions properly.
b)
Play/Record Voice Path: diagnoses whether the voice path in the playing/recording unit
functions properly.
Follow the steps below for System Diagnostic:
1.
Click Utility in the menu bar.
2.
Select Diagnostic.