Panasonic KX-TGP600G, Operating Instructions Manual

Page: 115 / 132

System Setting Menu Layout (when connected to the KX-TGP600)
Status
Sub Item Description Setting Default
Line Status Displays the line status.
Registered
*1
/Registering
*1
/
(NULL)
—
Firmware Version Selects which is shown on the
display the model number and
the firmware version. –Base Station
–Handset —
IP Mode Displays the IP network mode. IPv4/IPv6/IPv4&IPv6 —
IPv4 Settings Displays the information about
IPv4 settings.
–IP Address
*2
–Subnet Mask
*2
–Default Gateway *2
–DNS
*2
—
IPv6 Settings Displays the information about
IPv6 settings.
–IP Address
*3
–Prefix
*3
–Default Gateway
*3
–DNS
*3
—
MAC Address Displays the MAC address of
the base unit. — —
LLDP Displays the LLDP status. On/Off —
CDP Displays the CDP status. On/Off —
VLAN Displays the VLAN ID and
priority. — —
*1 If you select this item and press
OK
, the phone number of the selected line is displayed.
*2 If this item is not set, "0.0.0.0" is displayed. If the base unit does not connect to the Ethernet, "…" is
displayed.
*3 If this item is not set, "0::0" is displayed. If the base unit does not connect to the Ethernet, "::" is
displayed.
Network Settings
The administrator password may be required for this setting. Contact your administrator for further
information. For available characters, see “Character Table for Administrator Password”, Page 106.
Sub Item Description Setting Default
IP Mode Select Changes the network settings
of the base unit. Current
settings are displayed as a
highlight. –IPv4
–IPv6
–IPv4&IPv6 IPv4
115
Appendix