Panasonic KX-TGP600, Administrator'S Manual

Page: 27 / 396

3.
[ ]/[ ]: "
Network Settings
"
®
OK
4.
[ ]/[ ]: "
IPv6 Settings
"
®
OK
5.
[ ]/[ ]: "
DHCP
"
®
OK
6.
[ ]/[ ]: "
Auto
"
®
OK
•
Select "
Manual
" to enter the addresses for DNS1 (primary DNS server) and, if necessary, DNS2
(secondary DNS server) manually, and then press
OK
.
7.
To configure network settings automatically using RA
1.
/
2.
[ ]/[ ]/[ ]/[ ]:
®
OK
3.
[ ]/[ ]: "
Network Settings
"
®
OK
4.
[ ]/[ ]: "
IPv6 Settings
"
®
OK
5.
[ ]/[ ]: "
RA
"
®
OK
6.
Enter the addresses for DNS1 (primary DNS server) and, if necessary, DNS2 (secondary DNS server)
manually, and then press
OK
.
7.
To configure network settings manually
1.
/
2.
[ ]/[ ]/[ ]/[ ]:
®
OK
3.
[ ]/[ ]: "
Network Settings
"
®
OK
4.
[ ]/[ ]: "
IPv6 Settings
"
®
OK
5.
[ ]/[ ]: "
Static
"
®
OK
6.
Enter the IP address, Prefix (for IPv6), Default Gateway, DNS1 (primary DNS server), and, if necessary,
DNS2 (secondary DNS server), and then press
OK
.
7.
Note
•
If your phone system dealer/service provider does not allow you these settings, you cannot change
them even though the unit shows the setting menu. Contact your phone system dealer/service provider
for further information.
•
If you select "
DHCP
" for the connection mode, all the settings concerning static connection will be
ignored, even if they have been specified.
•
If you select "
DHCP
" for the connection mode and "
Auto
" for DNS, the DNS server settings (DNS1 and
DNS2) will be ignored, even if they have been specified.
1.1.4 Overview of Programming
There are 3 types of programming, as shown in the table below:
Programming
Type
Description References
Phone user
interface
programming Configuring the unit’s settings directly from the unit.
®
1.1.5 Phone User Interface
Programming
®
Section 3 Phone User
Interface Programming
Document Version 2017-07 Administrator Guide 27
1.1.4 Overview of Programming