Panasonic KX-TGH222C, Operating Instructions Manual

Page: 38 / 56

Key Operation
MDN or MCN Adjust the receiver/speaker
volume (during playback)
1 or MFN Repeat message (during
playback)
*1
2 or MEN Skip message (during
playback)
*2
3 Enter the “
Settings
” menu
4 Play new messages
5 Play all messages
6 Play greeting message
76 Record greeting message
8 Turn answering system on
M PAUSE N
Pause message *3
9 or
M STOP N
Stop recording
Stop playback
0 Turn answering system off
*4 *4 Erase currently playing
message
*5 Erase all messages
*6 Reset to a pre-recorded
greeting message
*1 If pressed within the first 5 seconds of a
message, the previous message is
played except when playing back from
the message list.
*2 When you play a message from the
message list, the unit stops message
playback and the display goes back to the
message list.
*3 To resume playback:
MbN : “
Playback
” a M SELECT N
*4 You can also erase as follows:
M PAUSE N a MbN : “
Erase
” a
M SELECT N a MbN : “
Yes
” a M SELECT N
Calling back (Call Display
subscribers only)
1
Press M PAUSE N during playback.
2
MbN : “
Call back
” a M SELECT N
n Editing the number before calling back
1
Press M PAUSE N during playback.
2
MbN : “
Edit
” a M SELECT N
3
Press M EDIT N repeatedly until the
phone number is shown in the desired
format (page 35).
a M N
Erasing all messages
1
M MENU N (right soft key) #325
2
MbN : “ Yes ” a M SELECT N a M OFF N
Advanced new message
alerting features
Audible message alert
This feature allows the base unit to beep to
inform you of a new message arrival when
new messages are recorded. The base unit
beeps 2 times every minute until you listen to
the messages, if the
“
Base unit beep
”
setting is turned on. The default setting is
“ Off ” .
1
M MENU N (right soft key) #339
2
MbN : Select the desired setting. a
M SAVE N a M OFF N
New message alert by a call
This feature allows you to receive a
notification by phone when new messages are
recorded. The base unit calls a phone number
you specify. You can then operate the
answering system remotely to listen to the
new message.
To use this feature, you must:
– store a phone number to which the unit
makes the call to.
– turn on the new message alert setting.
After you answer the new message alert call,
you can listen to messages from that call
(page 39).
Important:
R A new message alert is stopped 1 minute
after the unit starts to call. The unit will not
retry the call even if the call is not answered.
38
Answering System
TGH21xC(en)_0715_ver110.pdf 38 2014/07/15 15:51:30