Panasonic KX-TGH222C, Operating Instructions Manual

Page: 30 / 56

Using the phonebook’s group feature
(page 21), you can also select groups of
callers whose calls override night mode and
ring the handset (Call Display subscribers
only).
Important:
R Make sure the unit’s date and time setting
is correct (page 12).
R We recommend turning the base unit ringer
off (page 15) in addition to turning the night
mode on.
R If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
1
M MENU N (right soft key) #238
2
MbN : Select the desired setting. a
M SAVE N
R If you select “
Off
” , press M OFF N to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
4
* : Select “ AM ” or “ PM ” . a M OK N
5
Enter the desired hour and minute you
wish to end this feature.
6
* : Select “
AM
” or “
PM
” .
7
M SAVE N a M OFF N
Changing the start and end time
1
M MENU N (right soft key) #237
2
Continue from step 3, “Turning night
mode on/off”, page 30.
Selecting groups to bypass night
mode
1
M MENU N (right soft key) #241
2
Select your desired groups by pressing
1 to 9 .
R “ ” is displayed next to the selected
group numbers.
R To cancel a selected group, press the
same dial key again. “
” disappears.
3
M SAVE N a M OFF N
Call block
This feature rejects calls from unwanted
callers (Call Display subscribers only). The
following items are available when storing
phone numbers in the call block list (250 max.).
–
“
Block a single number
” : The unit
can reject calls from specific phone
numbers.
– “
Block range of numbers
” : The unit
can reject calls that begin with a number
stored in the call block list, such as a
toll-free phone number prefix or certain
area codes.
You can also set the unit to reject calls that do
not have a phone number.
When a call is received, the unit rings briefly
*1
while caller information is being received. If
the caller’s phone number matches an entry in
the call block list, the unit emits no sound to
the caller, and disconnects the call.
*1 This is called first ring. If you do not want
the first ring to sound, turn this setting to
“ Off ” (page 31).
Important:
R Rejected calls are logged in the caller list.
Storing unwanted callers
Storing a single phone number
Important:
R We recommend storing 10 digits (including
the area code). If only 7 digits are stored, all
numbers that have the same last 7 digits
will be blocked.
n From the caller list:
1
MCN CID
2
MbN : Select the entry to be blocked. a
M MENU N
R To edit the number: MbN : “
Edit
” a
M SELECT N
Press M EDIT N repeatedly until the
phone number is shown in the 10-digit
format. And then, press
M SAVE N . Go to
step 4.
3
MbN : “
Save caller ID
” a M SELECT N
30
Programming
TGH21xC(en)_0715_ver110.pdf 30 2014/07/15 15:51:30