Link to mobile feature
You can connect your base unit and mobile phone
using Bluetooth wireless technology, so that you
can make or answer mobile calls using your phone
system. This allows you to:
– use the unit to talk on mobile calls even if some
areas of your home have poor mobile reception,
simply by placing your mobile phone in an area
with good reception.
– talk on mobile calls even if your mobile phone is
in your pocket or bag.
– enjoy cordless mobile calls even if your mobile
phone plugged in and charging.
Important:
R
Your mobile phone must support the Hands
Free Profile (HFP) specification.
R
You may pair 2 mobile phones and 1 headset.
R
The unit can be used to talk on 2 lines at the
same time (for example, 2 mobile lines, or the
landline and 1 mobile line).
R
Only 2 Bluetooth devices can be used with the
unit at the same time (for example, 2 mobile
lines, or the headset and 1 mobile line).
R
Locate your mobile phone near the base unit. If
the mobile phone is too close to the base unit
during a mobile call, you may hear noise. For
best performance, we recommend placing the
mobile phone between 0.6 m to 3 m away from
the base unit.
Pairing a mobile phone
Important:
R
Before pairing a Bluetooth enabled mobile
phone to the base unit, make sure that no other
Bluetooth device such as a Bluetooth headset is
connected to your mobile phone.
1
Base unit:
Press and hold
M
MOBILE 1
N
or
M
MOBILE 2
N
for a few seconds.
R
After the corresponding MOBILE indicator
on the base unit starts flashing, the rest of
the procedure must be completed within 5
minutes.
2
Your mobile phone:
While the corresponding MOBILE indicator is
flashing, follow the instructions of your mobile
phone to enter the pairing mode.
R
Depending on your mobile phone, it may
ask you to enter the Bluetooth PIN (default:
“
0000
”
). If your mobile phone shows
PassKey confirmation on its display, follow
the directions to proceed.
3
Base unit:
Wait until a long beep sounds.
R
It may take more than 10 seconds to
complete pairing.
R
When the corresponding MOBILE indicator
lights up, the mobile phone is connected to
the base unit. You are ready to make
mobile calls.
4
M
EXIT
N
Note:
R
Make sure that your mobile phone is set to
connect to this product automatically. Refer to
your mobile phone’s operating instructions.
R
Make sure you cancel your mobile phone’s
current pairing if you want to pair it to the other
line (page 16).
R
The default setting for the alert feature is
“
On
”
,
so when you pair your mobile phone to the base
unit, this feature may be activated (page 55).
(This depends on the version and type of mobile
phone you are using.)
Unpairing a mobile phone
You can cancel the pairing of a mobile phone that
is stored in the base unit.
You can configure this setting using either the
base unit or one of the handsets.
Handset / Base unit
1
For MOBILE 1:
M
MENU
N#6111
For MOBILE 2:
M
MENU
N#6112
2
MbN
:
“
Yes
”
a
M
SELECT
N
R
When the mobile phone is unpaired, the
MOBILE indicator is turned off.
3
Proceed with the operation for your unit.
Handset:
M
OFF
N
Base unit:
M
EXIT
N
16
Link to Mobile
TGF38xAZ(en)_0319_ver001.pdf 16
2015/03/19 21:57:15