R
Only 2 Bluetooth devices can be used with the
unit at the same time (for example, 2 cellular
lines, or the headset and 1 cellular line).
R
For best performance, we recommend using a
Bluetooth headset within 1 m (3.3 feet) of the
base unit. A headset can communicate with the
base unit within a range of approximately 10 m
(33 feet).
Pairing a headset to the base unit
Important:
R
Make sure that the Bluetooth headset is not
connected to any other Bluetooth device.
Handset / Base unit
1
Your headset:
Set your headset to pairing mode.
R
Refer to the headset operating instructions.
2
M
MENU
N#621
3
If your headset PIN is “
0000
”,
go to step 4.
If your headset PIN is other than “
0000
”,
press
M
CLEAR
N
, then enter your headset PIN.
R
Typically, default PIN is
“
0000
”
. Refer to
the headset operating instructions.
4
Press
M
OK
N
, then wait until a long beep
sounds.
5
Proceed with the operation for your unit.
Handset:
M
OFF
N
Base unit:
M
EXIT
N
R
When
is displayed on the base unit, the
headset is available for use.
Connecting/disconnecting a headset
If you cannot connect the headset and base unit
using the headset, you can connect using the unit.
To use your headset with another Bluetooth
device such as a cellular phone, you may need to
disconnect it from the base unit.
You can configure this setting using either the
base unit or one of the handsets.
Important:
R
Make sure that the headset is turned on.
Handset / Base unit
1
To connect/disconnect:
M
MENU
N#622
R
A long beep sounds.
2
Proceed with the operation for your unit.
Handset:
M
OFF
N
Base unit:
M
EXIT
N
Unpairing a headset
You can cancel a pairing of the headset that is
stored to the base unit.
Handset / Base unit
1
M
MENU
N#612
2
MbN
:
“
Yes
”
a
M
SELECT
N
R
When the headset is unpaired, the
disappears from the base unit display.
3
Proceed with the operation for your unit.
Handset:
M
OFF
N
Base unit:
M
EXIT
N
Operating a Bluetooth wireless
headset using a landline
Important:
R
Refer to your headset operating instructions for
headset operations.
Answering landline calls with your headset
To answer a landline call, press your headset’s
button referring to your headset operating
instructions.
When you finish talking, press your headset’s
button referring to your headset operating
instructions.
Note:
R
If you cannot hang up the call using your
headset, press
MZN
on the base unit 2 times.
Switching between the base unit and your
headset
You can switch between the base unit and your
headset:
– during a landline call with the base unit.
– during an intercom call between the base unit
and handset.
– while listening to messages recorded on the
base unit answering system.
n
To switch to your headset:
Press
M
N
on the base unit.
n
To switch to the base unit:
Lift the corded handset to talk with the corded
handset.
or
Press
MZN
to talk with the speakerphone.
For assistance, please visit www.panasonic.com/support
55
Using Bluetooth® Devices
TGF38x(en)_1205_ver101.pdf 55
2014/12/05 10:20:15
