Panasonic KX-TGF342C, Operating Instructions Manual, Page: 36 / 64

3
Enter the desired hour and minute you
wish to start this feature.
4
* : Select “
AM
” or “
PM
” . a M OK N
5
Enter the desired hour and minute you
wish to end this feature.
6
* : Select “
AM
” or “
PM
” .
7
M SAVE N a M OFF N
Base unit
1
M MENU N#238
2
MbN : Select the desired setting. a
M SAVE N
R If you select “
Off
” , press M EXIT N to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
4
M AM/PM N : Select “
AM
” or “
PM
” . a M OK N
5
Enter the desired hour and minute you
wish to end this feature.
6
M AM/PM N : Select “ AM ” or “ PM ” .
7
M SAVE N a M EXIT N
Changing the start and end time
Handset / Base unit
1
M MENU N#237
2
Continue from step 3 for the handset or
step 3 for base unit, “Turning night mode
on/off”, page 35.
Selecting groups to bypass night
mode
Handset / Base unit
1
M MENU N#241
2
MbN : Select your desired groups. a
M SELECT N
R “ ” is displayed next to the selected
group numbers.
R To cancel the selected group:
MbN : Select the group. a Press
M SELECT N again. “ ” disappears.
3
M SAVE N
4
Proceed with the operation for your unit.
Handset: M OFF N
Base unit: M EXIT N
Baby monitor
This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house or place. The monitored handset
(placed in a baby’s room, for example) will
automatically call the monitoring handset,
base unit, or the phone number stored when it
detects sound.
Important:
R You should perform a test run of the baby
monitor procedure to ensure that the baby
monitor feature is set correctly. For
example, test its sensitivity. Check the
connection if you are diverting the baby
monitor to an outside line.
R This feature should not be used as a
substitute for a medical or caregiver’s
supervision. It is the caregiver’s
responsibility to stay close enough to
handle any eventuality.
Note:
R If the unit is connected to a PBX system,
you cannot set the baby monitor.
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
R The monitored handset never rings while it
is being monitored. If the base unit is
placed near the monitored handset, we
recommend turning off the base unit ringer
volume (page 33).
Setting the baby monitor
Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby’s room).
To monitor with a unit
The internal baby monitor feature is available:
– between handsets
36 For assistance, visit www.panasonic.ca/english/support
Programming