Main menu:
“
Key detector
Sub-menu 1
Sub-menu 2
Settings
Code
Search
–
–
#655
–
Battery check
–
–
*1 If you program these settings using one of the units, you do not need to program the same
item using another unit.
*2 This menu is not displayed when scrolling through the display menus. It is only available in
direct command code.
*3 When the cellular line only mode is turned on, these menus are not displayed (page 20).
*4 After the Bluetooth device is paired, the device name is displayed.
*5 For CELL 1
*6 For CELL 2
*7 The preset melodies in this product (
“
Tone 3
”
-
“
Melody 10
”
) are used with permission of
© 2009 Copyrights Vision Inc.
*8 The preset melodies in this product (
“
Tone 1
”
and
“
Tone 2
”
) are used with permission of
© 2013 Copyrights Vision Inc.
*9 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select
“
Caller ID auto
”
. To turn this feature off, select
“
Manual
”
. (Caller ID subscribers only)
To use this feature, set the date and time first (page 16).
*10 If you subscribe to a distinctive ring service (such as IDENTA-RING), select a tone (tone 1 or
2). If you select a melody, you cannot distinguish lines by their ringers.
*11 This tone lets you know when you receive an outside call while you are on another line or an
intercom call. If you select
“
On
”
, the tone sounds 2 times.
*12 This setting is available when you have the key detector (KX-TGA20). Read the installation
manual for more information on the key detector.
*13 For models with supplied key detectors, the display shows “
1:
Detector1
”.
*14 If you register 2 or more key detectors.
*15 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up
the handset to answer a call, turn off this feature.
*16 The flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary. The setting should stay at
“
700 ms
”
unless pressing
M
FLASH
N
fails to
pick up the waiting call.
*17 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to
“
A
”
if telephone line condition is not good.
For assistance, please visit http://shop.panasonic.com/support
41
Programming
TGD66x(en)_0420_ver020.pdf 41
2021/04/21 17:05:38
