4
3 CHANGES
3.1.
Things to Do after Replacing IC or X'tal
3.1.1.
Handset
[Changed from original section “11.6.1.2. Handset”]
First, operate the PC setting according to
The Setting Method of JIG
.
Then download the appropriate data according to the following procedures.
Note:
(*2) WW: country code, XXX_YYY: revision number
“XXX_YYY” vary depending on the country version. You can find them in the batch file, PNZZ- mentioned in
The Setting
Method of JIG
.
Items
How to download/Required adjustment
FLASH(IC4)
[for Suffix B or Later]
Adjusted parameter data is
stored in memory.
(country version batch file,
default batch file,ect)
1) Please be sure to execute the following steps if you have replaced the FLASH
IC(IC4).
1. Update BBIC. Refer How to update the BBIC.
2. Detach the JIG cable, then disconnect the battery.
3. Insert battery.
4. Connect the JIG cable again, and execute the command "getchk", then con-
firm the checksum value is correct.
• If the downloading failes, start again from step 1.
5. Check DECT ID written on Plastic bag of FLASH (IC4).
6. Execute the command "idw xx xx xx xx xx". xx xx xx xx xx: use DECT ID in
Step 5.
7. Execute the command "epw 00 01 01 00".
8. Default bath file: Execute the command "default.bat"
9. Common batch file: Execute the command
"TGCA20EUEX_DEF_RevXXX_YYY.bat"(*2).
10. Country version batch file: Execute the command
"TGCA20EUEX_WW_RevXXX_YYY.bat"(*2).
11. Confirm DECT ID written in the label pated plastic bag of FLASH rom.
12. Write ID(PFPI): Write DECT ID.
• Execute the command "IDWRITE". Refer to
11.4.3. Commands
.
2) Clock adjustment.
3) Battery low confirmation as below.
