–
5
–
Why is
w
flashing?
L
The handset is too far from the base unit. Move closer.
L
The AC adaptor is not connected. Check the
connections.
L
You are using the handset or base unit in an area with
high electrical interference. Place the handset and base
unit away from interference sources, such as antennas
and mobile phones.
L
The handset is not registered to the base unit. Register it.
J
(centre of joystick)
i
m
i
L
i
“
Registration
”
i
L
i
“
Register H.set
”
i
L
i
Select a base unit number.
i
L
i
Press
and hold
{x}
on the base unit for about 3 seconds, until the
registration tone sounds.
i
Wait until
“
Enter Base
PIN
”
is displayed.
i
Enter the base unit PIN (default:
“
0000
”
).
i
L
Why can I not make calls?
L
The dialling mode setting is incorrect. Set to
“
Tone
”
or
“
Pulse
”
as needed.
Why is the handset display
blank?
L
The handset is in screen saver mode. Press
{ih}
to
activate the handset display again.
L
The handset is not turned on. To turn the power on, press
{ih}
until a short beep sounds.
What should I do when the
handset does not turn on?
L
Make sure that the batteries are installed correctly.
L
Fully charge the batteries.
L
Clean the charge contacts and charge again.
How long should I charge new
batteries?
L
Charge the batteries for about 7 hours.
How long is the battery
operating time?
L
When you are using fully-charged Ni-MH batteries
(included batteries);
In continuous use: 15 hours max.
In continuous standby mode: 240 hours max.
– It is normal for batteries not to reach full capacity at the
initial charge. Maximum battery performance is
reached after a few complete cycles of charge/
discharge (use).
– Actual battery performance depends on a combination
of how often the handset is in use and how often it is
not in use (standby).
Can I keep the handset on the
base unit when I am not using
it?
L
Even after the handset is fully charged, the handset can
be left on the base unit without any ill effect on the
batteries.
Question
Cause & solution
TG9120FX(e-e)_QG.fm Page 5 Monday, August 28, 2006 9:29 AM
