Programming
30
L
According to your country selection in step 2, the
answering system announcement language
changes as follows (KX-TG8061):
L
After changing the unit’s region setting/
resetting the base unit,
_
is displayed on the
handset momentarily. This is normal and the
handset can be used once
w
is displayed.
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base unit.
Fontos:
L
The additional handset model recommended for
use with this unit is noted on 4. oldal. If another
handset model is used, certain operations
(handset settings, base unit settings, etc.) may
not be available.
Registering a handset to the base
unit
The supplied handset and base unit are pre-
registered. If for some reason the handset is not
registered to the base unit (for example,
_
is
displayed even when the handset is near the base
unit), re-register the handset.
1
Handset:
1
(middle soft key)
(
13
)
2
Base unit:
Proceed with the operation for your model.
■
KX-TG8051
Press and hold
{x}
for about 5 seconds.
(No registration tone)
■
KX-TG8061
Press and hold
{x}
for about 5 seconds,
until the registration tone sounds.
L
If all registered handsets start ringing,
press
{x}
again to stop, then repeat this
step.
L
The next step must be completed within 90
seconds.
3
Handset:
M
s
Wait until
“
Bázis PIN
”
is displayed.
s
Enter the base unit PIN (default:
“
0000
”
).
s
M
L
If you forget your PIN, contact an
authorised service centre.
L
When the handset has been registered
successfully,
w
is displayed.
Megjegyzés:
L
While registering,
“
Bázisállomás
regisztráció
”
is displayed on all registered
handsets.
L
When you purchase an additional handset, refer
to the additional handset’s installation manual for
registration.
Deregistering a handset
A handset can cancel its own registration to the
base unit, or other handsets registered to the same
base unit. This allows the handset to end its
wireless connection with the system.
1
1
(middle soft key)
(
131
L
All handsets registered to the base unit are
displayed.
2
{
r
}
: Select the handset you want to cancel.
s
M
3
{
r
}
:
“
IGEN
”
s
M
L
A confirmation tone sounds.
L
The handset does not beep when
cancelling its own registration.
4
{i
c
}
Increasing the range of the base unit
You can increase the signal range of the base unit
by using a DECT repeater. Please use only the
Panasonic DECT repeater noted on 4. oldal.
Contact your Panasonic dealer for details.
Fontos:
L
Before registering the repeater to this base unit,
you must turn the repeater mode on.
L
Do not use more than one repeater at a time.
Setting the repeater mode
1
1
(middle soft key)
(
138
2
{
r
}
: Select the desired setting.
s
M
s
{i
c
}
Megjegyzés:
L
After turning the repeater mode on or off,
_
is
displayed on the handset momentarily. This is
normal and the handset can be used once
w
is
displayed.
TG8051_8061PD(e-hg).book Page 30 Wednesday, February 2, 2011 2:33 PM
