Useful Information
26
Error messages
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect
the base unit AC adaptor and turn off the handset, then reconnect the base unit AC
adaptor and turn on the handset.
Telephone
Error message
Cause & solution
Memory Full
L
The handset’s phonebook memory is full. Erase
unnecessary entries (page 16).
No link to base.
Move closer to
base, try again.
L
The handset has lost communication with the base
unit. Move closer to the base unit and try again.
L
Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L
The handset’s registration may have been
cancelled. Re-register the handset (page 21).
You must first
subscribe to
Caller ID.
L
You must subscribe to Caller ID service. Once you
receive caller information after subscribing to Caller
ID service, this message will not be displayed.
Problem
Cause & solution
w
is flashing.
L
The handset is not registered to the base unit.
Register it (page 21).
L
The handset is too far from the base unit. Move
closer.
L
The base unit AC adaptor is not connected. Check
the connections.
L
You are using the handset or base unit in an area
with high electrical interference. Place the handset
and base unit away from interference sources,
such as antennas and mobile phones.
The handset display is
blank.
L
The handset is not turned on. Turn the power on
(page 11).
The handset will not
turn on.
L
Make sure that the batteries are installed correctly
(page 9).
L
Fully charge the batteries (page 10).
L
Clean the charge contacts and charge again
(page 10).
TG7200-7220HK(e-e).book Page 26 Tuesday, September 4, 2007 9:29 AM
Summary of Contents for KX-TG7200HK
Page 31: ...Notes 31 ...
