Changing the base unit PIN
(Personal Identification Number)
Important:
R
If you change the PIN, please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, contact
an authorised service centre.
1
M
N#132
2
Enter the current 4-digit base unit PIN
(default:
“
0000
”
).
3
Enter the new 4-digit base unit PIN.
a
M
OK
N
4
MbN
:
“
Yes
”
a
M
OK
N
a
MeN
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 5. Contact your Panasonic dealer for
details.
Important:
R
Before registering the repeater to this base
unit, you must turn the repeater mode on.
R
Do not use more than one repeater at a
time.
Setting the repeater mode
1
M
N#138
2
MbN
: Select the desired setting.
a
M
OK
N
a
MeN
Note:
R
After turning the repeater mode on or off,
may be displayed on the handset
momentarily. This is normal and the
handset can be used once
is displayed.
Registering the DECT repeater
(KX-A405) to the base unit
Note:
R
Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1
Base unit:
Proceed with the operation for your model.
n
KX-TG6811 series: page 3
Press and hold
M
N
for about 5
seconds. (No registration tone)
n
KX-TG6821 series: page 3
Press and hold
M
N
for about 5
seconds, until the registration tone
sounds.
R
The next step must be completed
within 90 seconds.
2
DECT repeater:
Connect the AC adaptor, then wait until
the
indicator and
indicator light
green.
3
Base unit:
To exit the registration mode, press
M
N
.
R
The registration tone stops.
(KX-TG6821 series: page 3)
31
Programming
TG68xxBX_UE(en)_0523_ver021.pdf 31
2013/05/23 16:41:16