Useful Information
42
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Battery recharge
Making/answering calls, intercom
Problem
Cause/solution
The handset beeps and/or
)
flashes.
L
Battery charge is low. Fully charge the
batteries (page 10).
I fully charged the batteries, but
)
still flashes.
L
Clean the charge contacts and charge again
(page 11).
L
It is time to replace the batteries (page 10).
I fully charged the batteries, but
the operating time seems to be
shorter.
L
Clean the battery ends (
S
,
T
) and the
charge contacts with a dry cloth and charge
again.
The handset display is blank.
L
The handset is not turned on. Turn the power
on (page 14).
Problem
Cause/solution
w
is flashing.
L
The handset is too far from the base unit.
Move closer.
L
The base unit’s AC adaptor is not properly
connected. Reconnect AC adaptor to the
base unit.
L
You are using the handset or base unit in an
area with high electrical interference. Re-
position the base unit and use the handset
away from sources of interference.
L
The handset is not registered to the base unit.
Register it (page 23).
Noise is heard, sound cuts in
and out.
L
You are using the handset or base unit in an
area with high electrical interference. Re-
position the base unit and use the handset
away from sources of interference.
L
Move closer to the base unit.
L
If you use a DSL/ADSL service, we
recommend connecting a DSL/ADSL filter
between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for
details.
The handset does not ring.
L
The ringer volume is turned off. Adjust ringer
volume (page 20).
The base unit does not ring.
L
The ringer volume is turned off. Adjust ringer
volume (page 21).
TG6411-6421E(e).book Page 42 Tuesday, December 16, 2008 7:54 AM
