Item
Meaning
In use
Answering system is being
used by the base unit or
another handset.
Line in use
Someone is using the line.
Initial settings
n
Direct command code:
Programmable settings can be accessed by
pressing
M
MENU
N
,
#
and then the
corresponding code on the dial keypad
(page 19).
Example:
Press
M
MENU
N#110
.
n
Symbol meaning:
Symbol
Meaning
Example:
MbN
: “
Off
”
Press
MCN
or
MDN
to select
the words in quotations.
Important:
R
When you install the batteries for the first time,
the handset may prompt you to set display
language and date and time.
Perform step 2 in “Display language”,
page 11, and then press
M
SELECT
N
.
Continue from step 2 in “Date and time”,
page 11.
Display language
You can select either
“
English
”
or
“
Français
”
as the display language. The default setting is
“
English
”
.
Base unit / Handset
1
M
MENU
N#110
2
MbN
: Select the desired setting.
a
M
SAVE
N
3
Proceed with the operation for your unit.
Base unit:
M
EXIT
N
Handset:
M
OFF
N
Date and time
Handset
1
M
MENU
N#101
2
Enter the current month, date, and year by
selecting 2 digits for each.
Example:
July 15, 2012
07
15
12
3
M
OK
N
4
Enter the current hour and minute (12-hour
clock format) by selecting 2 digits for each.
Example:
9:30
09
30
5
M
AM/PM
N
: Select
“
AM
”
or
“
PM
”
.
6
M
SAVE
N
a
M
OFF
N
Note:
R
When English is selected as the display
language, 12-hour clock format is used. When
French is selected, 24-hour clock format is used.
R
The date and time may be incorrect after a
power failure. In this case, set the date and time
again.
Voice guidance language
You can select either
“
English
”
or
“
Français
”
as the voice guidance language of the Talking Call
Display and answering system. The default setting
is
“
English
”
.
Handset
1
M
MENU
N#112
2
MbN
: Select the desired setting.
3
M
SAVE
N
a
M
OFF
N
Dialing mode
If you cannot make calls, change this setting
according to your telephone line service. The
default setting is
“
Tone
”
.
“
Tone
”
: For tone dial service.
“
Pulse
”
: For rotary/pulse dial service.
Handset
1
M
MENU
N#120
2
MbN
: Select the desired setting.
3
M
SAVE
N
a
M
OFF
N
11
Getting Started
TG477xC(en-en)_1214_ver021.pdf 11
2011/12/14 16:37:34
