Panasonic KX-TG234SK, Service Manual

Page: 54 / 99

54
KX-TG234SK/KX-TGA470B
12.2.4. Commands (Base Unit)
See the table below for frequently used commands.
12.2.5. Commands (Handset)
See the table below for frequently used commands.
Command name Function Example
rdeeprom Read the data of EEPROM Type “rdeeprom 00 00 FF”, and the data from address
“00 00” to “FF” is read out.
readid Read ID (RFPI) Type “readid”, and the registered ID is read out.
writeid Write ID (RFPI) Type “writeid 00 18 E0 0E 98”, and the ID “0018 E0 0E
98” is written.
hookoff Off-hook mode on Base Type “hookoff”.
hookon On-hook mode on Base Type “hookon”.
getchk Read checksum Type “getchk”.
How to use of
"getchk" 1.rdeeprom Read EEPROM Type “RdEeprom 03 F2 04”, and the data from address
“03 F2” to “03 F5” is read out
*This command gets 4 byte "WW", "XX", "YY", "ZZ".
*Please NEVER forget these 4 byte data!
2.sendchar epw Write EEPROM Type “sendchar epw 03 F2 04 FF FF FF FF”
3.sendchar RST Reset baseset Type “sendchar RST”
4.getchk Read checksum Type “getchk”.
5.sendchar epw Write EEPROM Type “sendchar epw 03 F2 04 WW XX YY ZZ”
*"WW", "XX", "YY", "ZZ" is 4 byte data that already read
from same address.
wreeprom Write the data of EEPROM Type “wreeprom 01 23 45”. “01 23” is address and “45”
is data to be written.
bs_burst Base unit outputs RF power in burst
test mode on antenna 2 Type"bs_burst"
tx_high Keep TX power high Type"tx_high"
tx_low Keep TX power low Type"tx_low"
Command name Function Example
rdeeprom Read the data of EEPROM Type “rdeeprom 00 00 FF”, and the data from address
“00 00” to “FF” is read out.
readid Read ID (RFPI) Type “readid”, and the registered ID is read out.
writeid Write ID (RFPI) Type “writeid 00 18 E0 0E 98”, and the ID “0018 E0 0E
98” is written.
getchk Read checksum Type "getchk"
How to use of
"getchk" 1.rdeeprom Read EEPROM Type “RdEeprom 03 7D 04”, and the data from address
“03 7D” to “03 80” is read out
*NEVER forget the read 4 byte data!
2.sendchar epw Write EEPROM Type “sendchar epw 03 7D 04 FF FF FF FF”
3.sendchar RST Reset baseset Type “sendchar RST”
4.getchk Read checksum Type “getchk”.
5.sendchar epw Write EEPROM Type “sendchar epw 03 7D 04 WW XX YY ZZ”
*"WW", "XX", "YY", "ZZ" is 4 byte data that already read
from same address.
weeprom Write the data of EEPROM Type”wreeprom 01 23 45”. “01 23” is address and “45”
is data to be written.
hs_burst Handset outputs RF power in burst test
mode Type"hs_burst"
tx_high Keep TX power high Type"tx_high"
tx_low Keep TX power low Type"tx_low"