R
The entered remote access code is deleted.
Using the answering system remotely
1
Dial your landline phone number from a
touch-tone phone.
2
After the greeting message starts, enter your
remote access code.
3
Follow the voice guidance prompts as
necessary or control the unit using remote
commands (page 62).
4
When finished, hang up.
Voice guidance
During remote operation, the unit’s voice guidance
starts and prompts you to press
1
to perform a
specific operation, or press
2
to listen to more
available operations.
Note:
R
If you do not press any dial keys within 10
seconds after a voice guidance prompt, the unit
disconnects your call.
Remote commands
You can press dial keys to access certain
answering system functions without waiting for the
voice guidance to prompt you.
Key
Operation
1
Repeat message (during playback)
2
Skip message (during playback)
4
Play new messages
5
Play all messages
9
Stop playback
0
Turn answering system off
*4
Erase currently playing message
*5
Erase all messages
*#
End remote operation
(or hang up)
*1 If pressed within the first 5 seconds of a
message, the previous message is played.
Turning on the answering system
remotely
1
Dial your phone number from a touch-tone
phone.
2
Let the phone ring 15 times.
R
A long beep is heard.
3
Enter your remote access code within 10
seconds after the long beep.
R
The greeting message is played back.
R
You can either hang up, or enter your
remote access code again and begin
remote operation (page 61).
Answering system settings
Call screening
Handset / Base unit
While a caller is leaving a message, you can listen
to the call through the unit’s speaker.
To adjust the speaker volume, press
MDN
or
MCN
repeatedly.
You can answer the call by:
– lifting the corded handset from the base unit, or
– pressing
M
N
on the handset.
Call screening can be set for each unit. The
default setting is
“
On
”
.
1
M
MENU
N#310
2
MbN
: Select the desired setting.
a
M
SAVE
N
3
Proceed with the operation for your unit.
Handset:
M
OFF
N
Base unit:
M
EXIT
N
Number of rings before the unit
answers a call
You can change the number of times the phone
rings
“
Ring count
”
before the unit answers
calls. You can select 2 to 7 rings, or
“
Toll
saver
”
.
The default setting is
“
4 rings
”
.
“
Toll saver
”
: The unit’s answering system
answers at the end of the 2nd ring when new
messages have been recorded, or at the end of
the 5th ring when there are no new messages. If
you call your phone from outside to listen to new
messages (page 62), you know that there are no
new messages when the phone rings for the 3rd
62
For assistance, visit www.panasonic.ca/english/support
Answering System for Landline
TG153CSK(en)_0422_ver021.pdf 62
2016/04/22 14:54:44
