Panasonic KX-TDE600GR, Service Manual

Page: 39 / 150

39
KX-TDE600GR
7.1.1.2. Pair Port Test
Tests the combination of an extension port and trunk port to ensure that communication with the trunk port can be carried out
successfully.
The pair port test can be carried out using one LCOT card and one DHLC, SLC8, SLC16 or MSLC16 card.
The tests that are performed are as follows:
To perform a pair port test
1. From the Utility menu, select Diagnosis.
2. Click on the Status cell of the extension card to be tested, and set it to "OUS".
3. Click on the cell showing the card type.
A new window will be displayed.
4. Select the Pair Port Test option.
A new window will be displayed. The card you selected in Step 3 will be shown in the Extension Line Slot No. drop-down list.
5. From the CO Line Slot No. drop-down list, select the slot number of the trunk card you want to test.
6. From the CO Line Port No. drop-down list, select the port number of the trunk you want to test.
7. Click OK.
The error report will be displayed.
8. Select an option:
• Click Capture if you want to save the displayed information.
1. Enter a file name, or select a file to overwrite.
2. Click Save.
• Click Cancel to return to the Diagnosis screen.
7.1.1.3. Utility-File Transfer PC to PBX (SD Card)
Copies PBX system files (program files, data files and activation key files) from the connected PC to the SD memory card
installed in the PBX. Pre-existing files on the SD memory card are overwritten.
This option is only available at Installer level.
The following types of files can be copied using this tool:
• Program files: These contain the programs used to operate cards within the PBX and CSs, acting as on-board drivers.
• Data files: These contain the initial configuration data for individual cards and settings.
• Activation Key files: These contain the activation keys used to enable the use of IP CO lines and IP telephones through Virtual
VoIP cards and upgrade the software.
Not all files that are copied using this tool are automatically made active. To install new program files, main system data, or acti-
vation key for software upgrade to the PBX, use the System Reset-Reset by the Command utility for PMMPR, DMSYS, and LIC
files. Use the Refresh Activation Key utility for other LIC files, and the SD Card File View and Load utility for all other files.
The PBX examines the header information of a file to determine 2 things: whether the file contains supported data, and which
system component the file applies to.
Only files whose header information matches that of a system file supported by the PBX can be transferred. Attempting to trans-
fer any other type of file results in an error message.
The names of all files that can be stored on the SD memory card are as follows:
Main Program
*: PMMPR-file-format data that is transferred to the PBX from the PC is saved as "PMMPR_S".
Line current OFF (Ext->CO) Line current from extension to trunk turns off.
Line current ON (Ext->CO) Line current from extension to trunk turns on.
Off hook detection (CO->Ext) Off-hook generation/detection from trunk to extension
DTMF detection (CO->Ext) DTMF generation/detection from trunk to extension
DP detection (CO->Ext) DP generation/detection from trunk to extension
BELL detection (Ext->CO) BELL generation/detection from extension to trunk
Speech path (Ext->CO) Speech path from extension to trunk
Speech path (CO->Ext) Speech path from trunk to extension
Name on SD Memory Card Corresponding Card
PMMPR IPCMPR
PMMPR_S IPCMPR*