3.5.5 Bandwidth
1.
Click
1.3.5 Bandwidth
in the operation menu.
Specify the maximum amount of bandwidth for VoIP (voice, data) communication on the network. If it
requires more bandwidth than is set here, packets will not be sent. In that case, voice packets (RTP
packets) are prioritized and data to be sent via the LAN will be discarded. The bandwidth restriction set
here does not influence IP packets that are received at the interface. Set the actual amount of bandwidth
(refer to "A.1.2 Bandwidth Requirements").
2.
Assign each parameter referring to the descriptions below.
Parameter & Description
Default
Value Range
WAN (Fixed IP Address/DHCP Client)
Specifies the bandwidth for the WAN port.
Applies to connection by a fixed IP address or
DHCP Client.
800
20–30000
PPPoE
Specifies the bandwidth for PPPoE.
Applies to connection by PPPoE.
800
20–30000
*1
When
Fixed IP Address
or
DHCP Client
is selected as the connection method in
WAN Interface
.
*2
When
PPPoE
is selected as the connection method in
WAN Interface
.
3.
Click
Set
.
A confirmation screen is displayed.
4.
The new settings must be followed by a reboot to become effective.
Do one of the following:
–
Click
Reboot Now
to make the changes effective now.
–
Click
Reboot Later
to return to the previous screen.
Note
After reboot, the card will be disconnected from the network for a number of seconds.
62
Installation Manual
Document Version 2008-10
3.5.5 Bandwidth
Summary of Contents for KX-TDA5450
